These are my links for August 5th through October 14th:
Using historical data to predict future conditions
This article, written by Gwyn Williams G4FKH and published in RadCom December 2011 is © RSGB 2011, reproduced with permission.
The RSGB 5MHz Experiment started toward the end of 2002, when the 5MHz Working Group was formed under the chairmanship of John Gould, G3WKL. The current NoVs for access to 5MHz expire on 30 June 2015, but it is possible that Ofcom and MoD will agree to a further extension. The 5MHz Experiment could then run well into the current solar cycle. On the website  are various ways in which information can be retrieved from the 5MHz database. In fact there are three separate parts to the database. The first two are concerned with the logging of the three propagation beacons that have been established: the first for manual logging and the second for automated logging. The third part is a compilation of propagation data for the same period. It suddenly occurred to me that the database could be used to forecast propagation.
This article and the subsequent web application discuss the automatically logged data and the propagation data. The three beacons in questions are GB3RAL, GB3WES and GB3ORK situated in Maidenhead Locator squares, IO91in, IO84qn and IO89ja respectively. They transmit on a frequency of 5.290MHz every quarter of an hour for one minute each, starting on the hour. Each sequence therefore lasts for three minutes. The logging software was designed by Peter Martinez, G3PLX and is available on the web via the experiment’s main page . To date, the automatic logging part of the database has accumulated over 1.3 million lines of data; the propagation part about one third of this. To perform the forecasts it is necessary to interrogate both of these datasets.
It will be appreciated that there are many stations contributing to the database and therefore there are an equal number of station setups! In order to explain the potential pitfall, I will explain my setup. I have a dipole aerial with a radio and PC. The output from the radio couples to the PC’s soundcard and the program manipulates data from the soundcard. My radio does not provide sufficient output to drive the soundcard, so I have installed an inline amplifier. I can, therefore, adjust my own recorded background/signal strength. Not taking care when analysing the data will cause these differences to become exaggerated. The G3PLX program compensates somewhat for this internally and displays the background signal level and the SNR of the station being monitored. This internal rationalisation and the forecasting program’s own scheme mitigate these differences.
I write small computer programs in the Perl language; during a fairly recent local club meeting I discussed this idea with Roger Pettett, G7TKI, a professional systems developer. My personal experience is not up to his standard and, as Roger kindly volunteered to develop the program in his own time, I quickly agreed. Roger is not au fait with propagation so the collaboration is a good one.
Before I go on to discuss the developed program and its usage, it seems expedient to first outline propagation at this frequency. Most of the propagation at this QRG is via NVIS (near vertical incidence skywave) communication. The E-layer (and probably, during some periods, the F-layer) do influence the longer distance circuits. NVIS for most practical purposes has a range of about 400km; therefore, if a station is set up in the middle of the UK, NVIS would be the dominant mode for the whole of the country. However, we do not live in an idealised world so a method is needed to perform forecasts between any two parts of the UK. To facilitate this database locators are used to correlate distances. The R12 (twelve-month smoothed relative sunspot number) and the AP (planetary A-index) are used to represent propagation conditions. R12 is automatically retrieved from the internet, but it is necessary to input the AP  that represents the propagation conditions under consideration. The best results within the UK will be achieved when using a 1⁄2λ dipole; the program suggests some aerial dimensions.
The ionosphere is fed by ionisation from the sun and this has a direct correlation with sunspot numbers. The ionosphere requires X amount of ionisation to allow for NVIS communication. For simplicity we can view the AP as a measure of disturbance in the ionosphere. The higher the AP, the worse the propagation will become.
Instead of using propagation prediction engines, eg VOACAP, we interrogate the databases to find parity (within parameters) to those conditions input by the user. A more complete introduction to NVIS communications can be found in .
5MHz FORECASTING PROGRAM
The completed program can be found at  and should be straightforward in use. As mentioned it is only necessary to input the AP, month, year and locator squares that are to be forecast, the last input tick is for a smoothed graph output. Figure 1 is an example of the input form. It can take a little time to search through the databases to find the correct matches; when the relevant data are found a table like Table 1 is produced along with a graph, Figure 2.
The table, which can be viewed as a median for a whole month, comprises three headed columns. The first column is the hour of the day, the second an SNR (signal to noise ratio) for the hour and the third an explanatory note for the SNR. For the purposes of this dataset an SNR below 20 should be considered as unreadable. The graph is a pictorial view of the table data; the thin green line is where the signal drops out of usability.
It may not be apparent why we need a tool such as the one described, because after all we have experience at this QRG and have other prediction tools at our left hand. What these things do not provide is the ability to visualise propagation when conditions are disturbed or changing. Inputting the correct answers into the input form allows the user to see what conditions will be like when the ionosphere becomes disturbed, such as from Coronal Mass Ejections and solar flares. This ability is lacking in prediction engines, but this program shows to what extent any degree of disturbance should have upon any circuit. However, there is one short-coming suffered by all forecasting tools and that is the ability to see things before they happen, ie a short- wave-fade from a large flare. This effect will last the same amount of time as the flare is visible from Earth (utilising the correct viewing techniques), from a minute or two, to perhaps an hour or so. These effects have a quick onset and an equally quick fall-off period.
Comparatively speaking and from interest the output from this program was compared with REC533, the same prediction engine used to produce the RadCom predictions (to be fair, predictions programs were never really designed for such short distances).
A survey was produced for RadCom in 2000 and REC533 was found to perform best. Comparing the output from REC533 (Table 2 Predicted SNR column) and what was actually copied using the automatic monitoring program (Table 2 Automatic Recording SNR column) showed that REC533 was only 25% accurate. When it is considered that this percentage of accuracy is only obtainable when geomagnetic conditions are quiet it shows a severe shortcoming.
Comparing this to the output from our new program (Table 2 Forecast SNR column) with an accuracy of 67% against actual monitoring, under all geomagnetic conditions, it shows the new program to be far superior to anything previously available. Comparison was carried out with the criteria of the SNR being within 10dB. In order to obtain more accurate results more data is required as well as data from a greater number of stations.
Table 3 and Figure 3 demonstrate the way in which conditions can change in reality. These clearly demonstrate the different conditions when an ionospheric disturbance is at hand. Of course it should be understood that diurnal conditions also have a bearing on the results shown in the table, ie at the very end and very beginning of the day, for some circuits no path is expected. What is happening is that the foF2 (F2 critical frequency) is dropping below the required frequency; this is when the E and F layers can accommodate communication.
This simple but effective idea can prove useful in all sorts of circumstances, ie for everyday amateur use, emergency situations (RAYNET) and other occasions outside the amateur service where 5MHz is in use, especially when conditions become disturbed during ionospheric upheavals. It is the use of a database with all varieties of propagation conditions that is the winning ingredient in performing accurate forecasts. As the database builds up to a crescendo in 2015, a whole solar cycle and more of information will have been logged and will provide an unsurpassed amount of quality data for this frequency.
 Near Vertical Incidence Skywave Communication, Theory, Techniques and Validation by LTC, David M Fiedler, (NJ ARNG) (Ret) and MAJ Edward J Farmer, PE (CA SMR). Published by Worldradio Books,
This article may also be downloaded in PDF format here: 5MHz Propagation Forecasting utilising the Experiment’s Database
These are my links for July 20th through September 15th:
- extundelete: An ext3 and ext4 file undeletion utility – bacon=saved
- 500 Internal Server Error – 500 Internal Server Error
- 500 Internal Server Error – 500 Internal Server Error
- ViTunes –
- Free Radio Network – why is internet linking *still* illegal in the uk?
With Discovery’s final trip earlier this week the ISS has been in the news again so I was interested to see this earlier today, received via John G0DET. Hopefully I’ll remember it’s happening and attempt to tune-in.
An ARISS School Contact is scheduled Saturday 12 March at 13:34 UTC (14.34 CEWT) for Shri Krishna Vithyaalayam Matric School, Pollachi (TK), India
The school is located in rural part of Tamilnadu state in India. The school has got a global partnership program with Westborough school in UK.
Mr.M.K.Anantha Ganesan, the founder and the Principal visited The Westborough school in September 2009. He is an amateur radio operator (VU3GPF). He visited the Chelmsford Amateur Radio Society and is made a honorary member. Anamalai Amateur Radio Club functions from our school.
The contact will be a telebridge, operated by IK1SLD.
Downlink signals will be audible over Europe on 145.800 MHz FM.
The conversation will be conducted in English. Students will ask as many of following questions as time allows.
- How many space walks are allowed and what purpose do space walks serve?
- How long the astronauts have to undergo the endurance tests?
- What type of food is taken by the astronauts?
- How far the Chandra x-ray observatory is useful in studying exotic phenomenon?
- What new construction is taking place in the ISS?
- What kind of scientific and technological experiments are undertaken by the astronauts?
- Please tell us about the emotional change that you undergo while spending moths together in space?
- Could you please tell us if the space junk will hamper space travel?
- What are your first impressions on seeing the mother earth for the first time from space?
- What steps have been initiated to reduce the impact of radiation exposure to the astronauts?
- What functions have been assigned to the Robonaut?
- Can you explain the term microgravity and how astronauts cope with that?
- What is your message to humanity as a whole and the students like us from India?
ARISS is an international educational outreach program partnering the participating space agencies, NASA, Russian Space Agency, ESA, CNES, JAXA, and CSA, with the AMSAT and IARU organizations from participating countries.
ARISS offers an opportunity for students to experience the excitement of Amateur Radio by talking directly with crewmembers onboard the International Space Station. Teachers, parents and communities see, first hand, how Amateur Radio and crewmembers on ISS can energize youngsters’ interest in science, technology and learning.
Gaston Bertels, ON4WF
Thanks to SEARS Canvey Island for the Co-op with India.
John G8DET CARS.